Remote Control Switch with magnetic base
No. 6906PB-4-4
- Login
- |
-
- |
Pump Unit
with 4 separate clamping circuits, single acting,
max. operating pressure 400 bar.
| Order no. |
Article no. |
Clamping circuits |
Q
[l/min] |
Valve type |
Matching control unit |
Weight
[Kg] |
CAD | SC |
|---|---|---|---|---|---|---|---|---|
| 326702 | 6906P-64319 | 4 | 2,5 | 4 x 3/2 + DS | 6906PB-4-4, 6906PB-4-5 | 65 | - |
Design:
Compact, plug-in pump unit, ready for electric and hydraulic operation. Complete with: pressure limiting valve and pressure switch, solenoid valve, pressure gauge, float switch, oil fill, electrical control with main switch, indicator lamps and flange sockets. Electrical connection complete with CEKON connector plug.
Application:
The pump unit is designed to operate hydraulic clamping systems.
Features:
The radial piston pump is driven via an alternating current standard motor with the energy efficiency class IE3. The motor is protected against overload by a motor protection switch and a thermoelement. Each of the 4 clamping circuits is equipped with a 3/2 seat valve. Four pressure switches (DS) are attached externally for the external pressure monitoring. Pressure setting and pressure monitoring are accomplished via a pressure limiting valve (DBV) and an electronic pressure switch (EDS). The value set at the pressure limiting valve is stored with the Mode button on the pressure switch. This simultaneously sets the preprogrammed switch-off and switch-back point.
The pump unit operates intermittently. In the case of a pressure drop, the pump unit is activated automatically by the pressure switch. The clamping pressure is indicated using illuminated push buttons. The installed float switch switches off the pump in the case of low oil level and outputs an optical signal.
Note:
Pay attention to faultless venting during the connection of the elements. Pumping in the case of pressure drop must be made maximum 2x per minute. The unit must not operate continuously. To ensure safe hydraulic tool clamping, clamping at ram and table is carried out in each case by means of a separate clamping circuit. The four pressure switches DS1-DS4 are used to provide external pressure monitoring of the four clamping circuits. The machine is automatically switched off if pressure drops in one clamping circuit or in the case of lack of oil. The electrical connection between press controller and power unit must be performed by the customer.