AMF
X
group picture
group picture

Installation clamping module, screw-in version

Pneumatic opening.
Opening operating pressure: min. 8 bar - max. 12 bar.
Retensioning operating pressure (turbo): min. 5 bar - max. 6 bar.
Cover and piston hardened.
Repeatability < 0.005 mm.

Order
no.
Size Pull-in/locking force up to
[kN]
Holding force*
[kN]
Blow out Weight
[g]
CAD SC
563900 KP5 1,5 13 150

Application:

Zero-point clamping system for set-up-time-optimised clamping during cutting and non-cutting machining. With small space requirement and low installation height.

Note:

The installation clamping module has high holding, pull-in and locking forces. This is opened pneumatically (1) and locked mechanically through spring force. To achieve the specified pull-in and locking forces, it must be briefly retensioned pneumatically (turbo) (2). Subsequent uncoupling of the pressure lines is possible at any time (module is clamped pressure-free). The contact surface is the upper surface of the housing. It is recommended to use the pneumatic pressure booster no. 6370ZVL.
The clamping module with blow-out has three connections: 1x pneum. Opening (1), 1x pneum. Retensioning (turbo) (2), 1x pneum. Blow-out and support control (3). (The pneumatic blow-out and support control can optionally be connected.)
The suitable installation tool is available under the AMF order no. 564855.
* Please observe the installation instructions.

On request:

- Installation diagrams

  • dimensions table
    Order
    no.
    Size dia. D
    dia. DN
    dia. D1 H HA dia. LK
    T
    563900 KP5 M45 x 1 15 39 19,8 5,8 36 14