max. operating pressure 250 bar,
min. operating pressure 25 bar.
Sp = clamp, Lo = unclamp
* Clamping force when using standard clamping lever
Hydraulic cylinder as a drop-in cartridge. Top mounting with four cylinder screws (resistance min. 10.9), these are included in the supply scope. All components from hardened, tempered and burnished steel. Piston rod and hinge pins from hardened steel, tempered and nitrided. Additional bronze wiper for piston rod protection.
Supply scope includes hinge pins and tension plates, but not clamping levers. Oil supply via oil channel in fixture body.
The double-acting link clamp is highly suited to clamping in clamping pockets.
Small dimensions. Allows close side-by-side positioning. Clamping levers easy to change with link clamps mounted. The clamping lever centre axis and the pressure point on the workpiece are always in one plane at (Z). This prevents relative movement on the workpiece. The integrated cartridge is stepped. This prevents the radial O-rings from becoming damaged as they are installed in or removed from the cross channels.
With standard levers, the ratio of B to C is 1 to 1.5.
In preparing the blank lever, deviations that cause a higher clamping force F1 are permitted only in exceptional cases.