AMF
X
group picture
group picture

Installation clamping module

Pneumatic opening.
Pneumatic blow out.
Operating pressure for opening: min. 5 bar - max. 12 bar.
Housing and piston hardened.
Repetition accuracy < 0.1 mm.

Order
no.		 Size Pull-in/locking force up to
[N] 		Holding force*
[N] 		Weight
[g] 		CAD SC
569368 RP260 100 3000 192  -
569369 RP270 300 6300 587  -

Design:

Contact surface with integrated blow out and support control.

Application:

Pneumatic zero-point clamping system for set-up-time-optimised clamping during cutting and non-cutting machining. Ideally suited for applications in the transfer automation range, since no interference contour is present underneath the interchangeable pallet.

Note:

The zero-point clamping system is opened (1) pneumatically and locked mechanically by spring force. The pneumatic supply lines can be connected using the M3 thread on the underside of the clamping module. Moreover, the air can be supplied using the O-rings supplied as standard. Subsequent uncoupling of the pressure line is possible at any time (zero-point clamping system is clamped at normal pressure). The connection (7) can optionally be used as a pneum. blow-out and support control. Venting is performed via a connection (5).

* Please observe the installation instructions.

On request:

- Installation drawing

  • dimensions table
    Order
    no.     		Size dia. D
    		 dia. D1 dia. D2
    		 ØDH G H H1 HA dia. LK
    		 dia. LK1 M T T1 T2
    569368 RP260 45 30 29,5 12 M3 43,5 20,5 8 38 24,0 M4 21,5 7 7
    569369 RP270 64 46 45,0 20 M3 64,6 32,0 10 55 38,4 M5 31,0 12 7


Matching accessories and similar products

Zero-point clamping sleeve

No. 6214ZN-XXX-01